Chapter 3 routine care and adjustment, Chapter 3, Routine care and adjustment – Genicom microLaser 170 User Manual

Page 68: Cleaning

Advertising
background image

Zebra XiII Printer User’s Guide

55

Chapter 3

Routine Care and
Adjustment

Cleaning

CAUTION:

Use only the cleaning agents indicated. Zebra Technologies Corporation
will not be responsible for any other fluids being used on this printer.

Table 5. Cleaning Schedule

Area

Method

Interval

Printhead

Solvent*

Direct Thermal Print Mode: After every
roll of media (or 500 ft. of fanfold media)

Thermal Transfer Print Mode: After every
roll of ribbon.

Platen Roller

Solvent*

Transmissive Media
Sensor

Air blow

Reflective (Black-Mark)
Media Sensor

Solvent*

Media Path

Solvent*

Ribbon Sensor

Air blow

Peel/Tear Bar

Solvent*

As needed.

Label Available Sensor

Air blow

Monthly.

Cutter Module

Solvent*

As needed.

* Zebra recommends using solvent containing 70% alcohol.

xi2ch3 Page 55 Tuesday, April 23, 1996 12:32 PM

Advertising
This manual is related to the following products: