Genicom microLaser 170 - Manual (Page 83)

Troubleshooting and Diagnostics
70 Zebra XiII Printer User’s Guide
Cancel Key Self Test
Turn the printer off. Press the Cancel Key and hold while turning the power
on. This self test prints a listing of the configuration parameters currently
stored in the printer’s memory. See Figure 15.
The configuration may be changed either temporarily (for specific label for-
mats or ribbon and label stock), or permanently (by saving the new parame-
ters in memory.) Saving new parameters occurs whenever a Calibration
procedure is performed. Refer to Chapter 2 for further information about the
Configuration procedure.
Figure 15. Cancel Key Self Test Sample Printout
xi2ch4 Page 70 Tuesday, April 23, 1996 11:58 AM