Genicom microLaser 170 - Manual (Page 62)

Ze
b
ra
Xi
II P
ri
n
te
r U
se
r’s
Gu
id
e
4
9
O
per
ati
o
n
L A N G U A G E
Selecting the Display Language Press the right or left oval key to display other choices.
Default: English Choices: English, Spanish, French, German, Italian
This parameter allows you to change the language used on the front panel display.
You have now completed the entire Configuration and Calibration sequence. You may do one of the following two things:
D A R K N E S S
You are now back at the first parameter in the configuration sequence.
S A V E S E T T I N G S
P R I N T E R R E A D Y
Save Settings Press the right or left oval key to display other choices.
Default: Permanent Choices: Permanent, Temporary, Cancel, Load Defaults, Load Last Save.
This display appears when you attempt to exit the configuration mode.
• Permanent: Permanently saves the changes, even when printer power is turned off.
• Temporary: Saves the changes until changed again or until power is turned off.
• Cancel: Cancels all changes since you entered the configuration mode except for Darkness and
Tear-Off Position (if they were changed).
• Load Defaults: Loads factory defaults. Note: Loading factory defaults will require Calibration
and resetting the Head Resistor value.
• Load Last Save: Loads the values from the last permanent save.
Press the Next/Save key to activate the displayed choice.
You have exited the Configuration and Calibration Sequence and you are now ready for normal
printer operation
xi2ch2
Page 4
9
Tuesda
y
, Apr
il
23,
1996
1:
45
PM