Genicom microLaser 170 - Manual (Page 29)

Getting Started
16 Zebra XiII Printer User’s Guide
Adjusting the Upper Media Sensor Position
Note: If you own a 140XiII or 170XiII printer and need to move the sensor to the
outside half of the maximum media width, or from the outside half to the
inside half, contact a service technician to perform this procedure because it
will require additional steps which are beyong the scope of this user’s
guide.
To adjust the upper media sensor, follow these steps.
1. Remove ribbon if it is installed.
2. Locate the Upper Media Sensor. Refer to Figure 4. The Upper Media
Sensor is directly below the adjustment screw head.
3. Loosen the Upper Media Sensor Adjustment screw (Phillips head).
Figure 4. Upper Media Sensor Adjustment
xi2ch1 Page 16 Tuesday, April 23, 1996 12:22 PM