Genicom microLaser 170 - Manual (Page 84)

Zebra XiII Printer User’s Guide 71
Troubleshooting and Diagnostics
Pause Key Self Test
This self test can be used to provide the test labels required when making
adjustments to the printer’s mechanical assemblies. See the sample printout
in Figure 16.
Turn the printer off. Press the Pause key and hold while turning the power
on.
1. The initial self test prints 15 labels at speed “A” (2.4” per second) then
automatically pauses the printer. Each time the Pause key is pressed, an
additional 15 labels print.
2. While the printer is paused, pressing the Cancel key alters the self test.
Now each time the Pause key is pressed the printer prints 15 labels at
speed “D” (6” per second).
3. While the printer is paused, pressing the Cancel key again alters the self
test again. Now each time the Pause key is pressed the printer prints 50
labels at speed “A”.
4. While the printer is paused, pressing the Cancel key again alters the self
test a third time. Now each time the Pause key is pressed the printer
prints 50 labels at speed “D”.
5. While the printer is paused, pressing the Cancel key again alters the self
test a fourth time. Now each time the Pause key is pressed the printer
prints 15 labels at 12” per second.
Figure 16. Pause Key Self Test Sample Printout
xi2ch4 Page 71 Tuesday, April 23, 1996 11:58 AM