Mocomtech SLM-5650 - Manual (Page 150)

SLM-5650 Satellite Modem Revision 1
Remote Control MN/SLM5650.IOM
B–28
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Number of
Unread stored
Events N/A 3 bytes Query only.
Unit returns the Number of stored Events, which remain Unread, in
the form xxx.
Note: This means unread over the remote control.
Example: NUE=126 N/A NUE? NUE=xxx
(see description of
arguments)
Initialize
Events Pointer IEP= None Command only.
Resets internal pointer to allow RNE? queries to start at the
beginning of the stored events log.
IEP=
IEP# N/A N/A
Retrieve next
5 unread
Stored Events N/A 110 bytes Query only.
Unit returns the oldest 5 Stored Events, which have not yet been
read over the remote control. Reply format: {CR}Sub-
body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body,
where Sub-body= Axxxxxxxxddmmyyhhmmss,
A being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Info
xxxxxxxx is the Fault Code number, as in LUF?, TXF?, RXF?, or
Info Code, which is:
00000000=Power Off
00000001=Power On
00000002=Log Cleared
00000004=Global Config Change
If there are less than 5 events to be retrieved, the remaining
positions are padded with zeros.
If there are no new events, the response is RNE*.
N/A RNE? RNE={CR}Axxxxxxxxd
dmmyyhhmmss{CR}Ax
xxxxxxxddmmyyhhmms
s{CR}Axxxxxxxxddmm
yyhhmmss{CR}Axxxxx
xxxddmmyyhhmmss
{CR}Axxxxxxxxddmmy
yhhmmss
(see description for
details of arguments)
Clear All
Stored Events CAE= None Command only.
Forces the software to clear the software events log.
Example: CAE=
Note: This command takes no arguments
CAE=
CAE?
CAE*
CAE# N/A N/A