E.2 physical description, E.3 general specifications – Mocomtech SLM-5650 User Manual

Page 178

Advertising
background image

SLM-5650 Satellite Modem

Revision 1

CDI-70 Gigabit Ethernet Interface MN/SLM5650.IOM

E-2

E.2 Physical

Description

The GbE is implemented on a 4.5 W x 6.8 D x .85 H inches (11.43 W x 17.27 D x 2.16H cm)
PCB. Connectivity to the SLM-5650 will be implemented with a 96-pin DIN receptacle, and the
LAN interface consists of an RJ-45 connector with link status and link activity Light-Emitting
Diode (LED) indicators (at minimum).

E.3 General

Specifications

Table E-1. Interface Specifications

General Specifications

Data Framing

10/100/1000 Base-T Interface: RFC-894 “Ethernet”

Data Framing Format
(WAN)

HDLC (Standard Single Channel)

Connector

RJ-45 female, 100

Ω

Electrical Properties

Per IEEE 802.3ab

Packet Types

Burst, distributed, or IPV4

Signal Types

Serial data

Voltage Level

Per IEEE- 802.3ab

Packet Latency

50 ms maximum

Flow Control

None

Cable Length, Maximum

100 meters CAT 5 cable, patch cords and connecting hardware,
per ISO/IEC 11801:1995 and ANSI/EIA/TIA-568-A (1995)

Hot Pluggable (cable)

Yes

Hot Pluggable (card)

NO

LEDs

Link Status, link activity

Ingress Packet Filtration
Parameters

MAC, IP address match value configuration for media and
management packets, UDP port for media packets

Egress Packet
Parameters

Destination IP address and UDP port for media packets

Packet Filtration
Parameters (generic)

IP address match value configuration for management packets

1000Base-T Link
Statistics

Ingress good octets
Ingress bad octets
Ingress unicast packets
Ingress broadcast packets
Ingress multicast packets
Ingress pause packets
Ingress undersize packets
Ingress fragments
Ingress oversize packets
Ingress jabber

Advertising