Mocomtech SLM-5650 - Manual (Page 157)

SLM-5650 Satellite Modem Revision 1
Remote Control MN/SLM5650.IOM
B–35
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Remote
Modem AUPC
Enable RPC= 1 byte, values
of 0 or 1 Command or Query.
Remote Modem AUPC Control, where:
0=Off
1=On
Example: RPC=1 (Turn on remote modem AUPC Control) RPC=
RPC?
RPC*
RPC# RPC? RPC=x
(see description of
arguments)
Remote
Modem
Pattern
Substitution RPB= 1 byte, values
of 0 or 1 Command or Query.
Remote Modem Tx Pattern Substitution, where:
0=Off
1=On
NOTE: For compatibility reasons, only the 2047 Tx pattern can be
turned On or Off at the remote modem..
Example: RPB=1 (Turn on remote modem AUPC Control)
RPB=
RPB?
RPB*
RPB# RPB? RPB=x
(see description of
arguments)
Remote
Modem I/O
Loopback RPL= 1 byte, values
of 0 or 1 Command or Query.
Remote Modem I/O Loopback Mode, where:
0=Off
1=On
Example: RPL=1 (Turn on remote modem AUPC Control) RPL=
RPL?
RPL*
RPL# RPL? RPL=x
(see description of
arguments)
Remote
Modem BERT
BER N/A 6 bytes Query only.
Unit returns the value of the remote modem’s BERT BER in the
form a.b x 10
-c . First three bytes are the value. Last two bytes are
the exponent. Returns 0.0E00 if the BERT is not synchronized to a
pattern.
Example: RPE=4.0E06
N/A RPE? RPE=a.bEcc
(see description of
arguments)