Mocomtech SLM-5650 - Manual (Page 91)

SLM-5650 Satellite Modem Revision 2
Front Panel Operation MN/SLM5650.IOM
4–21
Select: CONFIG: Remote: Remote: Ethernet
If Ethernet was selected:
IP Address/Range Permits the user to select the IP address .
MAC Displays the modem’s MAC address, this is programmed at the
factory and is not user changeable. If installed, the Gigabit Ethernet
interface’s MAC address will also be displayed.
Gateway The IP Gateway address is the default address that the modem will
send all IP responses when the message originated from a source
outside the modems local attached network.
SNMP Permits the user to select and control Communities or Traps.
GigaBit Interface
Address/Range Permits the user to set the Gigabit Ethernet interface’s management
IP address and subnet mask (range).
IMPORTANT
For the address fields the value of the digit is changed using the
 arrow keys. The user should then press [E]
4.3.2 Select: Monitor
Alarms Permits the user to select and view Tx, Rx, or Unit alarms.
Event-Log Permits the user to select View, or clear-all stored events.
Rx-Params Permits the user to view FC, RSL, BERT, Buffer, Eb/No, or BER.
Statistics Permits the user to select View, Clear-All or Config statistics.
GigaBit I/F Gigabit Interface link statistics.
Permits the user to select View or Clear-All.
Ethernet Config: IP Address/Range MAC
Gateway SNMP GigaBit I/F Addr
Monitor: Alarms Event-Log Rx-Params
Statistics GigaBit I/F Stats