Mocomtech SLM-5650 - Manual (Page 84)

SLM-5650 Satellite Modem Revision 2
Front Panel Operation MN/SLM5650.IOM
4–14
Select: CONFIG: Receive: Frequency
Edit the Rx Frequency, using either step 1 or 2:
1. Key in the desired frequency using the numbered keypad.
2. Select the digit to be edited, using the
 arrow keys. The value of the digit is
then changed using the arrow keys. The user should then press [E]
7/140 MHz 52-88, 104-176 MHz (in 100 Hz steps)
L-Band 950-2000 MHz (in 100 Hz steps)
Spectrum Normal or Invert, (used to counteract frequency converters that invert the
spectrum)
IMPORTANT
When entering an IF frequency, the M&C will check the occupied
bandwidth calculated from the data rate, modulation type, code rate
and overhead, and will not allow an IF frequency to be entered if the
occupied bandwidth falls outside of the minimum or maximum IF
frequencies.
Select: CONFIG: Receive: Acquisition
Edit the value as described in step 1 or 2 as follows:
1. Key in the desired frequency range using the numbered keypad.
2. Select the digit to be edited, using the

arrow keys. The value of the digit is
then changed using the  arrow keys. The user should then press [ENTER].
Range 0 to 60 kHz in 1 Hz steps, Demodulator Acquisition range
Reacq 0 to 999 seconds, Hold off time before the demodulator reverts to normal
acquisition. During the holdoff the demodulator will stay centered on the last
known frequency position of the carrier for faster reacquisition.
Rx Frequency: 1955.0000 MHz
Spectrum: Normal (
efE)
Acquisition: Range: 0001.000 KHz
Reacq: 000 Seconds (
efbcE)