Sony HM-982RW - Manual (Page 13)

System connection
13
Knowledge section
Preparation section
Application section
Basic section
R
L
SUB WOOFER
PRE OUT
OUT IN
A U X
DIGITAL IN
OPTICAL
DIGITAL IN
OPTICAL
R
L
SUBWOOFER
PRE OUT
OUT @ @ @ IN
A U X
DIGITAL IN
OPTICAL
R
L
OUT IN
A U X
¶ 1
0
2
7
3
¡
8
2. Connection of Other Accessories
(Commercially Available Parts)
Conection of Subwoofer (optional)
Extremely low frequency sound is played back powerfully.
Connection of external source component
Subwoofer
Cassette deck etc.
Optical fiber cable
Digital component
1.In case an associated system component is connected, also read the instruction manual of the component.
2.Insert the optical-fiber cable straight into the connector until it clicks.
3.Be sure to attach the protection cap when the connector is not used.
4.Never bend or bundle the optical-fiber cable.
Notes Notes
Be sure to retain the cap removed above.
When connections are to be made, make sure
that the power plug is not plugged into a wall AC
outlet. Connect the equipment as shown in the
figures.
Analog signal connection
The AUX (OUT/IN) input jacks on the rear panel can be used to connect a cassette deck, etc.
audio input
R
L
SUB WOOFER
PRE OUT
OUT @ @ @ IN
A U X
DIGITAL IN
OPTICAL
SUB WOOFER
PRE OUT
audio output
Optical digital audio output
Digital signal connection
The OPTICAL digital input jack on the rear panel can be used to connect a digital component.
For the digital signals which can be recorded and played on this system, see "Sampling frequency".
A
The source connected to the DIGITAL IN OPTICAL jack cannot be recorded onto tape. To record an external source
on tape, connect the source component's output to the AUX IN jacks and select the "AUX" input source.