Sony HM-982RW - Manual (Page 68)

68
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
Select the “CD” input. Be sure to put the CD recorder and cassette deck in stop mode.
The PGM Twin Recording makes it possible to record desired tracks programmed in the desired order on a CD-R/
RW and tape simultaneously. (High-speed recording is not available.)
The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with
certain discs. (CD-R/RW only)”Digital recording and SCMS”
A
Program twin recording onto CD-R/RW and Tape
(PGM mode + TWIN REC)
CD CDR
=
TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
Before recording
When digital-to-digital recording is not impossible
or when analog-to-digital recording is performed,
select the analog input as described in the follow-
ing section then start the setting from step
1
below.”Changing the recording input setting” e
DIGITAL
Check the current play mode of the CD player.
2
If it is in play mode, stop it.
1
Make the preparations for recording.
÷ High-speed recording is not available in the Twin Recording
mode.
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN
indicator may blink for a while.
“OPC (Optimum Power Control)”
‡
1 CDR........Place a recordable CD-R or CD-RW disc.
fl
TAPE ...... Perform steps 1~3 of the procedure
in”Recording on TAPE”. ‚
2 Select the “CD” input. ¢
3 Load the recording source disc in the CD player.
¢
7
Program the desired sequence of CD tracks.
3
Perform steps 2 and 3 of the procedure in ”Lis-
tening in the desired sequence (Program play-
back)”.
u
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
The current setting is displayed.
"DIGITAL" is lit ......... Digital-to-digital recording
"DIGITAL" not lit ...... Analog-to-digital recording
CDR