Switching the time display during recording – Sony HM-982RW User Manual

Page 42

Advertising
background image

Recording on TAPE

42

Preparation section

Basic section

Apprication section

Knowledge section

Switching the time display during recording

Press the DISPLAY key to switch the display to the
information on the recorder side.

DISPLAY

÷ The display can also be switched with the DISPLAY key on

the remote.

Playback side (CD player, etc.)

Recorder side (CD recorder)
(Displayed only in simultaneous
twin recording)

Recorder side (Cassette deck)

Recorder side (Cassette deck)

DECK

T A P E

0 0 0 7

If the audio output level of the auxiliary analog source such as a cassette deck is too low or too high, recording
at the optimum level may not be available.
In this case, perform the following adjustment before recording.

Adjusting the input level from the auxiliary analog source (AUX Input, Rec Gain)

1 Press the AUX/D-AUX key repeatedly until "AUX"

is displayed.

2 Press the MENU key.

3 Press the MULTI CONTROL keys to select “AUX

Input ?”, then press the SET key.

4 Press a MULTI CONTROL keys to adjust the record-

ing level (between -5 and +2).

5 Press the SET key to set the selection.

A U X I n

0

A U X
I n p u t ?

Blinks

Level value

Adjusting the input level from the auxiliary analog source (AUX Input)

Adjust so that the audio from the auxiliary analog source sounds at the identical level to the audio from the internal source
such as the CD.

÷ If the input level from the auxiliary analog source is still too

low or the recorded audio level is too low even after the
input level is maximized (to +2) by this adjustment, perform
the recording input level adjustment operation (Rec Gain)
described below.

Adjusting the recording level of the input from the auxiliary analog source (Rec Gain)

1 Press the AUX/D-AUX key repeatedly until "AUX"

is displayed.

2 Press the MENU key.

3 Press the MULTI CONTROL keys to select “Rec

Gain ?”, then press the SET key.

4 Press a MULTI CONTROL keys to select "High".

5 Press the SET key to set the selection.

÷ When this is set to "High", the sound may sometimes be

distorted due to too high recording level.

R e c

G a i n ?

R . G a i n
H i g h

Blinks

Advertising