Sony HM-982RW - Manual (Page 47)

47
Various playback features
Knowledge section
Preparation section
Application section
Basic section
Listening in the desired sequence
(Program playback)
1
Check that the unit is in the stop mode.
2
3
Light the “PGM” indicator.
Enter track Nos. in the order you want to play
them.
4
Start playback.
Select the “CD” input. ¢
÷ The track can also be selected using the 4 or ¢ key.
÷ Up to 32 tracks can be programmed. When “PGM Full” is
displayed, no more tracks can be programmed.
÷ If you do not press the SET key before the track number
display stops blinking, the track number entry is canceled.
1 Select a track number using numeric keys.
÷ Tracks will be played in the order they were programmed (in
order of PGM-Nos.).
÷ When the 4 or ¢ key is pressed during play, the program
will jump to the preceding or the following track respectively.
÷ When the 4 key is pressed once during playback, the play
position returns to the beginning of the current track being
played.
Press the 7 STOP key.
Press the CD
6 key.
Press the PGM key.
If it is in play mode
Blinks
Press the numeric keys as shown below....
To enter track No. 12 .... +10, 2
To select track No. 20 ... +10, +10, 0
\ \
2 Press the SET key.
3 Repeat steps 1 and 2.
Desired tracks in a disc can be programmed in the
desired order and played back. (Max. 32 tracks)
2 Programming 1 Track selection
CD
To make a CD-R/RW disc playable on a CD player, it
is required to finalize the disc.
∏
PGM
AUTO/MONO
1 2 3
4 5 6
7 8 9
+10
C D 0 1
0 : 0 0
TOTAL
REMAIN
PGM
C D - -
P - 0 1
TOTAL
REMAIN
PGM
C D 0 8
P - 0 1
TOTAL
REMAIN
PGM
C D 0 8
P - 0 1
SET
STOP
7
6
CD
7 STOP
CD
6
CLEAR
4,¢
PGM
Numeric keys
SET
Go to step
2
within 20 sec.
÷ After the adjustment, the time display appears again.
Blinks