Sony HM-982RW - Manual (Page 64)

64
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
Check the current play mode of the CD player.
2
1
1 Perform steps 1~3 of the procedure in ”Recording
on TAPE”. ‚
2 Load the recording source disc in the CD player.
¢
Make the preparations for recording.
Be sure to put the cassette deck in stop mode.
Records all tracks in a CD with a simple operation. (All-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
One-touch edit recording
(O.T.E.)
All track recording Single-track recording
If it is in play mode, stop it. Select the desired CD track and play it.
Start recording.
3
÷ When either the playback or recording operation stops, the
other operation also stops.
÷ When you are operating the main unit, select “O.T.E. Mode”
in the menu mode then select “CD = = = = =TAPE“ and press the
SET key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
To interrupt a recording
CD TAPE
=
STOP
7
6
CD
CD =TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
Press the 7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
÷ Even when the O.T.E. CD= = = = =TAPE key is pressed in the middle
of a track, recording will start from the beginning of the track.