Sony HM-982RW - Manual (Page 69)

69
Knowledge section
Preparation section
Application section
Basic section
Convenient recording of CD player output
Start recording.
4
To interrupt a recording To finalize the recorded CD-R/RW ∏
Display "CDR Writing" indicates that recorded data
is being written in the CD-R/RW. Do not apply
vibrations or impact during recording and "CDR
Writing" display.
If the power cord is unplugged from the power
outlet or a power failure occurs during recording, the
disc data may be destroyed and the disc may be-
come unusable.
Press the
7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
÷ When the CD-R/RW does not have available recording time at
all or the tape has been wound till the end, recording cannot
be started.
÷ When the CD playback stops, other operations also stop
automatically.
÷ When you are operating the main unit, select “O.T.E. Mode”
in the menu mode then select “Twin Rec“ and press the SET
key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
CDR
During digital-to-digital recording, the CD recorder
may encounter a track with which digital-to-digital
recording is prohibited. In this case, "SCMS"(
A) is
displayed and recording pauses temporarily, but play-
back of the source continues and recording restarts
whenever a track with which digital-to-digital record-
ing is permitted is encountered. However, if "SCMS"
is displayed with the first track to be recorded, the
track as well as the subsequent tracks will not be
recorded.
÷ With certain discs, digital-to-digital recording may be prohib-
ited by SCMS ( A). Such a disc should be recorded using
the analog output signal. e
÷ "CDR Writing" is displayed when recording completes.
TWIN
REC