Sony HM-982RW - Manual (Page 83)

83
In case of difficulty
Knowledge section
Preparation section
Application section
Basic section
A CD is placed in the player but it cannot be played.
Sound is not produced.
Sound skips.
÷ Place the disc properly, with the label side facing upward.
÷ Clean the disc referring to “Disc handling precautions”.
9
÷ Refer to “Caution on condensation” and remove the condensa-
tion by evaporation. A
÷ If the disc is a CD-R/RW, finalize it. ∏
÷ Press the CD 6 key.
÷ Clean the disc referring to “Disc handling precautions”.
9
÷ Clean the disc referring to “Disc handling precautions”.
9
÷ Install the unit in a place not subject to vibrations.
Remedy Symptom
CD player section
Remedy Symptom
Cassette deck
÷ Clean the head referring to “Maintenance”. ;
÷ Play a recorded tape.
÷ Change the tape transport direction or reverse the tape inser-
tion orientation. •ª
÷ Clean the head referring to “Maintenance”. ;
÷ Try another tape.
÷ Adjust the AUX input level (AUX Input, Rec Gain). w
÷ Demagnetize the head referring to “Maintenance”. ;
÷ Install the system at a distance from other electric appliances
and TV.
÷ Set the "DOLBY NR" to on. ª
÷ Clean the head referring to “Maintenance”. ;
÷ Wind the tape again by fast forwarding, rewinding or playing
from an end to the other. ª
÷ Use a cassette with an unbroken recording protect tab or block
the hole.
0
÷ Set the input selector to the source to be recorded. q
÷ Change the tape transport direction or reverse the tape inser-
tion orientation. •ª
Sound cannot be produced by pressing the play key.
No operation occurs even when an operation key is
pressed.
Sound is harsh or high frequencies are not reproduced.
Sound is distorted.
Noise is noticeable.
Sound vibrates.
Recording cannot be started by pressing the record key.