Sony HM-982RW - Manual (Page 28)

Playback of TAPE
28
Preparation section
Basic section
Apprication section
Knowledge section
tape loading mechnism
2 2
1 1
1. Insert a cassette tape.
Playback of TAPE
2. Start playback. (The “TAPE” input is selected automatically.)
The cassette tape cannot be loaded or ejected while the unit is in standby
mode. Do not force load a cassette tape in standby mode, otherwise
malfunction will result.
Ejecting
the cassette
tape
2 2
To reduce tape noise
(DOLBY NR)
Selection of
reverse mode
Tape counter
Transport direction indicators
Indicates the tape transport direction
during playback or recording by light-
ing of
2 or 3. This direction is the direc-
tion stored in memory when the tape
was last stopped.
T A P E
0 0 0 7
TAPE
23
Start playback
To stop playback
To wind tape at high speed
Start playback
Selection of reverse mode
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
T A P E
0 0 0 0
To wind tape at high speed
During playback, the tape running direction changes each time the TAPE
23
key is pressed.
To stop play-
back
÷ The cassette deck can play back Normal (TYPE ), High-position (TYPE ) and Metal
(TYPE ) tapes.
÷ Remove tape slack before loading.
Insert the cassette tape straight into
the insertion slot. Just push lightly
and the cassette will be pulled auto-
matically inside, and TAPE IN indica-
tor lights.
In the direction of the arrow
Reverse mode
indicators
Transport di-
rection indica-
tors
To play (record) this side, play
(record) tape by setting the tape
transport direction to "
3".
To play (record) the other side,
play (record) tape by setting the
tape transport direction to "
2".
Direction of insertion
into main unit
\