Sony HM-982RW - Manual (Page 56)

56
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
3
1
2
1 Place a recordable CD-R or CD-RW disc. fl
2 Load the recording source disc in the CD player.
¢
Make the preparations for recording.
Select the recording speed.
Check the current play mode of the CD player.
Be sure to put the CD recorder in stop mode.
High-speed recording makes possible digital-to-digital recording from a CD to CD-R/RW at a double speed. (High-
speed recording is not available in analog-to-digital recording.)
The recording source can be a finalized CD-R, but digital-to-digital recording may not be available with certain
discs.”Digital recording and SCMS”
A
High-speed recording of all tracks in a CD
(O.T.E.) (High)
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN
indicator may blink for a while.
“OPC (Optimum Power Control)” ‡
÷ High-speed recording from a CD-RW is not possible. The CD-
RW should be recorded at the normal speed. P
1 Press the MENU key.
2 Press the MULTI CONTROL keys to select “O.T.E.
Speed ?”, then press the SET key.
3 Press the MULTI CONTROL keys to select “<High>”,
then press the SET key.
4
Start recording.
÷ The high-speed playback sound of the CD is played at a low
volume during high-speed recording.
÷ High-speed recording starts with the first track in the CD and
continues until the last track.
÷ When either the CD playback or CDR recording operation
stops, the other operation also stops.
÷ Although high-speed recording starts digital-to-digital record-
ing automatically, this may sometimes be unavailable due to
the SCMS (
A). In this case, record the analog input at the
normal speed. P
1 Press the MENU key.
2 Press the MULTI CONTROL keys to select “O.T.E.
Mode ?”, then press the SET key.
3 Press the MULTI CONTROL keys to select
“CD
=CDR<High>”, then press the SET key.
Each press switch the modes as follows.
<High> ............ (Recording at double speed)
<Norm> .......... (Recording at normal speed)
Each press switch the modes as follows.
CD =CDR<High>
CD
=TAPE
Twin Rec
\ \
\ \
#
#
MULTI
CONTROL
SET
7
#
#
MULTI
CONTROL
SET
If it is in play mode, stop it.
When you are operating the remote, press the O.T.E.
CD
=CDR key.
CD CDR
=