Sanyo DHX4852 - Manual (Page 103)

1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
3-55
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Control of W-2WAY ECO-i SYSTEM
4. System Controller
III - 43
TD831078
How to check overlapping of central address No.
(1) Press the and
ZONE
buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C3 by pressing ,
( ) button and press the button.
C3 changes from flashing to ON state and
will flash. Then auto. overlap checking will start .
(3) If C3 changes from ON to flashing and
stops flashing and disappears, there is no over-
lapping.
Then finally, complete the auto overlap checking
mode by pressing the
button.
(4) If some of GROUP No., ZONE No. and UNIT No.
flash, you should try again the zone registration.
1 Select CODE No. C1 by pressing ,
( ) button and press the button.
2 Select the flashing GROUP No. with ZONE
and GROUP button.
Then press the
button and reselect the
ZONE, GROUP and UNIT No.
3 Then finally, complete the auto. overlap
checking mode by pressing the button.
2054_M_I
ZONE
ZONE 1
ZONE SELECT
GROUP
9
2 3 4 6
Fig. 3-35
TD831138-02_W-2WAY.indb 55 2007/07/26 14:31:53