Sanyo DHX4852 User Manual
Page 83
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
3-35
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
3. Timer Remote Controller
1. Press and hold
for more than 2 seconds to display the upper limit temperature
setting screen.
,
and the upper limit temperature start flashing.
(The default value of the upper limit temperature is 99 °F.)
2. Press
/
to select the upper limit temperature and press
to fix the
value. The lower limit temperature setting screen is displayed.
3. Press
/
to select the lower limit temperature, and press
to fix the
value. The outing function setting is completed. (The default value of the lower limit
temperature is 50 °F.)
*
The unit returns to the normal mode if
is pressed or there is no operation made for 3
minutes during the setting. In this case, all the settings in progress will be lost.
Canceling the outing function
Press and hold
for more than 2 seconds while the outing function is set.
Setting the Outing Function
Outing Function (Continued)
Outing function indication
Outing function indication
Status
Off
The outing function is not set.
Flashing
The outing function is now being set, or under operation.
Lighting
Although the outing function is set, not under operation.
Note
A remote controller loses outing function operation information when it is cut for more than one hour during the outing function
operation by electricity. It reverts from the blackout, and an air conditioner does not drive in outing function when operation is
started. At this time, an air conditioner does not stop at outing function.
2
3
TD831138-02_W-2WAY.indb 35
2007/07/26 14:31:41