Sanyo DHX4852 - Manual (Page 65)

1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
3-17
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
1. Insert a screwdriver or similar tool into the notch at the
bottom to remove the receiver nameplate.
2. Cut a section out of the ceiling along the provided paper
pattern (3 - 47/64" × 2").
3. Pass the wire through the provided mounting bracket and
insert the bracket into the installation hole. (Fig. 3-17)
4. Use bracket parts (A) and (B) to securely grip the ceiling
material. (Fig. 3-18)
5. Connect the receiver wire (2-core) to the wire from the
indoor unit.
(Refer to “Wiring the Receiver Unit.”)
Check the terminal number on the indoor unit before wir-
ing the receiver unit and be sure not to wire incorrectly. (The
unit will be damaged if high voltage, such as 200 VAC, is
applied.)
6. Adjust the provided spacers so that they are several mil-
limeters larger than the thickness of the ceiling material.
Pass the 2 supplied screws (M4
× 40 or 5/32" ×1-37/64" )
through the spacers and tighten them enough to hold the
receiver unit in place.
7. Return parts (A) and (B) through the gap between the
ceiling and receiver unit so that they are contained in the
openings. Then tighten the screws.
Do not tighten the screws excessively. This may result in
damage or deformation of the case.
Tighten to the point where the receiver unit can be moved
slightly by hand. (Fig. 3-19)
8. Reattach the nameplate.
Fig. 3-17
Part (B)
Part (A)
Fig. 3-18
Fig. 3-19
TD831138-02_W-2WAY.indb 17 2007/07/26 14:31:21