Kawasaki STX-15F - Manual (Page 120)

3-66 FUEL SYSTEM (DFI)
Throttle Lever, Cable and Case
•
Disassemble the throttle case.
○
Remove the circlip [A], flat washers [B], pin [C], throttle
lever [D] and return spring [E] from the case [F].
Throttle Case Assembly/Installation
•
Insert the end of the return spring [A] in the throttle lever
hole [B] and set the spring in the throttle case [C] as
shown.
•
Install the control lever to the case.
•
Lubricate the throttle cable before assembly/installation.
•
Apply water resistant grease to the tips of the throttle ca-
ble end.
•
Pulling the throttle cable [A], position the tips [B] of the
cable end as shown.
•
Tighten the cable fitting nut.
•
Be sure the rubber cap [A] is in place on the throttle cable
fitting nut end.
•
Cover the cable fitting nut [B] with the rubber boot [C].