Kawasaki STX-15F - Manual (Page 319)

HULL/ENGINE HOOD 13-13
Fittings
Handrail Removal
•
Remove the seat (see this chapter).
•
Disconnect the bilge hoses from the breather fitting.
•
Unscrew the mounting nut [A] and washer inside the hull,
and remove the lock assembly [B].
•
Holding the nuts and washers inside hull, unscrew the
mounting bolts [C], and remove the handrail [D].
Handrail Installation
•
When installing the lock assembly and handrail, align the
projection [A] and stud bolt [B] on the lock assembly with
holes [C] on the hull.
Drain Plug Housing Removal
•
Unscrew the screws [A] and remove the drain plug hous-
ing [B].
Drain Plug Housing Installation
•
Check the seal [A] for damage.
If necessary, replace new ones.
○
Install the new gasket [B] so that its “OUT” mark [C] faces
outwards.
Exhaust Outlet Removal
•
Unscrew the mounting bolts [A] and remove the holder [B]
and exhaust outlet [C].
Exhaust Outlet Installation
•
Apply a non-permanent locking agent to the mounting
bolts and tighten them securely.