Kawasaki STX-15F - Manual (Page 218)

7-4 ENGINE REMOVAL/INSTALLATION
Engine Removal/Installation
Engine Removal
•
Remove:
Seat (see Hull/Engine Hood chapter)
Oil Separator Tank (see Lubrication Sytem)
•
Plug the hose end [A].
If the engine disassembles, drain the oil (see Engine Oil
Change in Periodic Maintenance chapter).
•
Remove:
Air Filter (see Fuel System (DFI) chapter)
Inlet Manifold (see Fuel System (DFI) chapter)
Exhaust Manifold (see Exhaust System chapter)
Bolts [A] and Ignition Coil Bracket
•
Remove:
Cooling Hoses [A]
○
The oil hose [B] is not necessary removal.
NOTE
○
If the oil is in the engine and the removed hose lies
down, the oil will flow out from hose end.
•
Remove:
Starter Motor Cables [A]
Cooling Hoses [B]
•
Disconnect:
Alternator Lead Connector [A]