Kawasaki STX-15F - Manual (Page 269)

DRIVE SYSTEM 10-7
Drive Shaft/Drive Shaft Holder
○
Press the small grease seal, and the large grease seals,
bearing, and small grease seals come out of the holder.
[A] Sleeve
[B] Blocks
[C] Press
Drive Shaft Holder Assembly/Installation
•
Replace the grease seals with new ones.
•
Press the bearing and grease seals into the drive shaft
holder, noting the following.
○
Install the parts in this order.
Two Small Grease Seals [A]
One Bearing [B]
Two Large Grease Seals [C]
Front [D]
Special Tool - Bearing Driver Set: 57001-1129
○
Install the seals so that the sides with the spring face out-
ward.
○
Fill the gaps between the seals with water resistance
grease [E].
•
Install the circlip.
•
Apply water resistance grease to the bearing inner sur-
face and grease seal lips.
•
Install the drive shaft holder on the bulkhead so that the
circlip side face toward the front.
•
Apply a non-permanent locking agent to the drive shaft
holder mounting bolts, tighten them loosely.
•
Install the drive shaft.
•
After installing the engine, tighten the drive shaft holder
mounting bolts to the specified torque to give proper cou-
pling alignment.
Torque - Drive Shaft Holder Mounting Bolts: 22 N·m (2.2
kgf·m, 16 ft·lb)
•
Make sure the clearance [A] between the engine coupling
[B] and the drive shaft coupling [C] is 3
∼ 5 mm (0.12 ∼
0.20 in.).