Kawasaki STX-15F - Manual (Page 234)

8-14 ENGINE BOTTOM END
Stator
Stator Removal
•
Remove:
Engine (see Engine Removal/Installation chapter)
Magneto Cover (see Coupling/Output Shaft Removal)
Grommet Cover Mounting Bolts [A]
Grommet Cover [B]
Stator Mounting Bolts [C] with Washers
Stator Assembly [D]
Stator Installation
•
Apply water resistant grease to the outside of the grom-
met.
•
Apply a non-permanent locking agent to the grommet
cover bolts.
•
Tighten:
Torque - Grommet Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
•
Apply a non-permanent locking agent to the stator mount-
ing bolts and put the washers.
•
Tighten:
Torque - Stator Mounting Bolts: 12 N·m (1.2 kgf·m, 104
in·lb)
○
When installing the stator, fix the stator lead to the groove
of the magneto cover.
○
Be sure to the stator lead have no slack and bite.