Service code (character) table, Fuel system (dfi) 3-23 – Kawasaki STX-15F User Manual

Page 77

Advertising
background image

FUEL SYSTEM (DFI) 3-23

Self-Diagnosis

Service Code (Character) Table

Service

Code

(used in

ECU)

Service Code

Character

(displayed on

Meter Unit)

Possible Problems

Fail-Safe Function

11

Throttle sensor malfunction,
wiring open or short

The ECU locks ignition timing into
the ignition timing at closed throttle
position and sets the DFI in the D-J
method (see Note 1).

12

Inlet air pressure sensor
malfunction, wiring open or short

The ECU sets the DFI in the α-N
method (see Note 2).

13

Inlet air temperature sensor
malfunction, wiring open or short

The ECU sets the inlet air temperature
at 40°C.

14

Water temperature sensor
malfunction, wiring open or short

The ECU sets the water temperature
at 70°C.

21

Crankshaft sensor malfunction,
wiring open or short

–

23

Camshaft position sensor
malfunction, wiring open or short

The ECU continues to ignite cylinders
in the same sequence following the
last good signal.

31

Vehicle-down sensor
malfunction, wiring open or
short

The ECU slows down the engine
speed less than 3 000 r/min (rpm) by
stopping the ignition.

41

Injector #1 malfunction, wiring
open or short

–

42

Injector #2 malfunction, wiring
open or short

–

43

Injector #3 malfunction, wiring
open or short

–

44

Injector #4 malfunction, wiring
open or short

–

51

Ignition coil #1, #4 malfunction,
wiring open or short

The ECU shuts off the injectors #1/#4
to stop fuel to the cylinders #1/#4.

52

Ignition coil #2, #3 malfunction,
wiring open or short

The ECU shuts off the injectors #2/#3
to stop fuel to the cylinders #2/#3.

71

Engine overheat

The ECU slows down the engine
speed less than 3 000 r/min (rpm) by
stopping the ignition.

72

Engine oil pressure too low

The ECU slows down the engine
speed less than 3 000 r/min (rpm) by
stopping the ignition.

(JT1500-A1)

73

(JT1500-A2

∼

)

Oil temperature sensor
malfunction, wiring open or
short

The ECU sets the oil temperature at
60°C.
The ECU slows down the engine
speed less than 3 000 r/min (rpm) by
stopping the ignition.

76

(JT1500-A2

∼

)

Engine oil overheat

The ECU slows down the engine
speed less than 3 000 r/min (rpm) by
stopping the ignition.

Advertising