Kawasaki STX-15F - Manual (Page 281)

PUMP AND IMPELLER 11-11
Pump and Impeller
•
Remove the bearing by tapping evenly around the bearing
inner race from the front end of the pump case [A].
Special Tool - Bearing Driver Set: 57001-1129 [B]
JT1500-A2 ∼ ;
•
Press [A] the bussing [B] and the ball bearing [C]. They
come out of the pump case.
•
Remove the circlip.
•
Remove the grease seals.
Special Tool - Oil Seal & Bearing Remover: 57001-1058 [A]
JT1500-A1,A2 ∼ ;
•
Insert a metal rod [A] into the pump cap [B] from the rear
end, remove the bearing by tapping evenly around the
bearing inner race from the rear end of the pump cap.
Pump Assembly
•
Before installing the cap bearing, blow any dirt or foreign
particles out of the pump cap [A] with compressed air.
•
Install new bearing into the cap as far as it will go.
Special Tool - Bearing Driver Set: 57001-1129 [B]