Life Fitness 93T User Manual
Page 123
3-8
Front Roller
Mounting Bolt
Lock Washer
Flat Washer
Front Roller
Rear Roller
Rear Roller
Adjusting Screws
Deck
Deck
Screws
Deck
Screws
Striding
Belt
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Striding Belt and Deck - Continued
Special Service Tools Required: NONE
13. Move the Striding Belt aside to gain to remove the Anti-
Static Tinsel.
14. With the tinsel and rollers removed, remove the Striding
Belt from the Frame and discard.
STRIDING BELT INSTALLATION
Note: Use the exploded view to aid in re-assembly and
installation of treadmill components.
1.
Position the new striding belt inside the unit.
Note: Make sure that the arrow on the inside of the belt
points in the direction of belt rotation.
2.
Replace the Anti-Static Tinsel at this time, and install
between the side frames.
3.
Position the Front Roller under the Striding Belt and
install the Motor Drive Belt back on the Front Roller
Pulley. Then place the Right Side Shaft in the
Access Hole and secure the Left Side Front Roller
Shaft with the mounting bolt and washers.
4.
Install new Deck or flip the existing Deck. Secure
the Deck with the four mounting screws.
5.
Before installing the Rear Roller, remove any wax
build-up on the roller. Position the Rear Roller under
the Striding Belt. Make sure that the “R”
identification mark at the end of the roller shaft is
positioned accordingly for proper bearing wear.
6.
Secure the Rear Roller Adjusting Screws by hand.
DO NOT TIGHTEN THESE SCREWS AT THIS
TIME. The belt should remain loose.
7.
Adjust the Striding Belt. See “How To...” on the
following pages.
8.
After the Striding Belt is properly adjusted, reinstall
the inside Upright Covers, Motor Cover, and Front
Cover.
9.
Refer to the Diagnostics Section to log-in
maintenance repair of the striding belt.
Anti-Static
Tinsel