Life Fitness 93T - Manual (Page 143)

3-28
Wax Lift PCB
Motor
Controller
PCB
Frame Tag
Board
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Frame Tag Board
Special Service Tools Required: NONE
1. Turn the unit power OFF at the switch,
and then unplug the line cord at the
wall outlet.
2. Remove the inside Upright Covers,
Front Cover, and Motor Cover. See
“How to…” in this section.
3. Remove the Wax Lift Assembly. See
“How To…” in this section.
NOTE: In the illustration, a portion of the
treadmill frame has been removed in order
to show the frame tag board.
4. Disconnect the electrical connector on the
Frame Tag Board.
5. There are four Spring Clips, which hold the
Frame Tag Board in place. Squeeze the Spring
Clips to release the Frame Tag Board.
6. Remove the Frame Tag Board from out of the
left side of the frame.
7. Install new Frame Tag Board onto same Spring
Clips in reverse order.