Life Fitness 93T - Manual (Page 141)

3-26
Wax Lift Board
Motor
Controller
PCB
Capacitor PCB
Capacitor
Board Cable
Wax Lift
Bracket
Motor
Controller
Wax Lift Board
Bracket
Wax Lift
Board Assembly
Capacitor
Board Cable
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Motor Controller Assembly, Wax Lift Assembly, and Capacitor PCB
Special Service Tools Required: NONE
1. Turn the unit power OFF at the switch, and then
unplug the line cord at the wall outlet.
2. Remove the Inside Upright Covers, the Front
Cover, and the Motor Cover. See “How to…” in
this section.
3. Depending on which is being replaced, disconnect
the appropriate wiring from the Motor Controller
Assembly or from the Wax Lift Assembly.
CAUTION! Before beginning the following steps,
ALL LEDs on the Motor Controller MUST BE OUT.
4. To remove the Motor Controller Assembly:
Disconnect the Capacitor Board Cable from the
Motor Controller Assembly. Next remove a total of
five mounting screws which secure the Motor
Controller Assembly to the base of the Unit.
Remove two screws in the front of the Unit and
three at the base of the Unit, then lift out the Motor
Controller Assembly.
5. To remove the Wax Lift Assembly: Disconnect
the Capacitor Board Cable from the Motor
Controller Assembly. Remove two screws at the
base, and then lift it out.