Life Fitness 93T - Manual (Page 43)

2A-18
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
DIAGNOSTICS: SYSTEM TEST – BELT / DECK TEST
This test allows the user to check the belt and deck condition. This test acts as a wattage meter. It will give the user
the percentage of power, wattage, bus voltage, and temperature readings.
The following messages will scroll:
The initial information displayed will be:
Where XXX will indicate real values.
PERCENT is the percentage of available power. It will range from 0 to 100%.
WATT is the wattage measured by the motor controller to move the belt ranging from 340 to 1200 watts.
By pressing the ‘COOL-DOWN’ key, the display will toggle to the information displayed below.
Where XXX will indicate real values.
VOLTAGE is the bus voltage of the motor controller. It is not the input line voltage.
TEMP is the temperature measure of the motor controller heat sink in Celsius.
The display will lock on the current information if the ‘PAUSE’ key is pressed.
The speed system and incline systems can be activated in this test. However, the display will only show the target
speed or incline for two seconds while the speed/incline keys are being pressed. It will then return to showing the
belt/deck information.
To test if the belt and deck need replacement: Using the ‘SPEED’ Up Arrow Key, walk on the unit at 3.5 mph for
a minimum of 1 minute. Then run on the unit at 7.0 mph for a minimum of 1 minute. If the watts are higher than
1100, replace the belt and either flip or replace the deck.
Press the ‘CLEAR’ key to exit the Belt/Deck test and return to the System Test Menu.