Life Fitness 93T - Manual (Page 156)

3-41
Console Back Screws(8)
Console PC Board
(Remove from back
of Console Front)
Console PC Board/
Overlay Bezel Assembly
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
How To... Replace the Overlay Bezel
Special Service Tools Required: NONE
Note: The Overlay Bezel is part of the Console Front Assembly, however, the Console PC Board is not. Therefore,
the Console PC Board must be removed from the back of the Console Front.
1. Turn the unit power OFF at the switch, then
unplug the line cord at the wall outlet.
2. Remove eight screws from the Console Back.
3. Lift the Console Front off just enough to
disconnect the electrical connectors from
the Console PC Board.
5. Remove the screws securing the Console
PC Board to the back of the Console
Front, and then disconnect the Ribbon
Cables from the Console PC Board. Now
set the PC Board aside for re-use on the
new Overlay Bezel.
6. Install new Overlay Bezel Assembly in
reverse order. Make sure that all
connectors and ribbon cables are
securely fastened to the Console PC
Board.
7. Refer to Diagnostics Section to Log
Maintenance Repair of the Overlay Bezel.