Life Fitness 93T - Manual (Page 13)

1-6
Life Fitness Model 97Te, 95Te, 97Ti, 95Ti and 93T Arctic Silver Treadmills
TROUBLESHOOTING GUIDE
SYMPTOM PROBABLE CAUSE CORRECTIVE ACTION
Insufficient power source. Plug treadmill into a proper electrical
configuration. Refer to the Operations
Manual. No Power.
Circuit breaker, if equipped. Verify that circuit breaker is not open. If
open, reset circuit breaker, if equipped.
Insufficient power source. Plug treadmill into a proper electrical
configuration. Refer To The
Operations Manual.
Loose 10-pin connection at display
console or wax/lift control board. Check all electrical connections for
proper attachment.
Damaged main harness wire
connection. Replace wire harness. See How
To…Replace Main Wire Harness.
Row of six LEDs not lit. Check that the EEPROM in the Wax
Lift Board is seated properly. If
necessary replace the Wax Lift Board.
Display does not illuminate
when machine is powered
on.
Wax/Lift Board EEPROM not seated or
missing. If row of 6 LEDs not lit on top of
Wax/Lift Board, then check that the
EEPROM in the Wax/Lift Board is
seated properly. Replace the Wax/Lift
Board if necessary.
Striding Belt slips during
footfall. Striding belt slips on front roller during
stall test. Check striding belt & re-tension as
necessary. See How…To Adjust Belt
Tension.
User is pushing striding belt. Instruct users not to push striding belt
in either direction.
Striding belt/deck malfunction. The
deck laminate worn through or the
underside of striding belt glazed over
(hard, glossy). Replace belt and deck. See How
To…Replace Striding Belt.
Maximum speed is
reduced.
Insufficient power source. Plug treadmill into a proper electrical
configuration. Refer to the Operations
Manual.
Knocking sound at rear of
machine. Faulty rear roller bearings. Replace rear roller assembly.
Knocking sound coming
from deck. Life Springs not positioned correctly
and/or loose mounting hardware. Reposition or tighten life springs.