Lexmark 9300 Series - Manual (Page 158)

Cannot print from a Bluetooth-enabled device
Make sure that the Bluetooth mode and the Bluetooth
Discovery mode are enabled on your printer
1 From the control panel, press or repeatedly
until Setup is highlighted.
2 Press .
3 Press or repeatedly until Change
Bluetooth Default Settings is highlighted.
4 Press .
The Bluetooth Default Settings menu appears with
the option for
Bluetooth Enabled highlighted.
5 Press or repeatedly until On appears.
6 Press or repeatedly until the option for
Discovery Mode is highlighted.
7 Press or repeatedly until On appears.
8 Press .
Make sure you type in the correct pass key If you set Security to High, you must type in the pass
key from another Bluetooth-enabled device
Consider setting Security to Low to eliminate the need
for a pass key:
1 From the control panel, press or repeatedly
until Setup is highlighted.
2 Press .
3 Press or repeatedly until Change
Bluetooth Default Settings is highlighted.
4 Press .
The Bluetooth Default Settings menu appears.
5 Press or repeatedly until the option for
Security is highlighted.
6 Press or repeatedly until Low appears.
7 Press .
Make sure that the external Bluetooth-enabled device is
configured to communicate with the Bluetooth adapter
connected to your printer For more information, refer to the documentation that
came with the external Bluetooth-enabled device.
Copy troubleshooting
• “Copier does not respond” on page 159
• “Scanner unit does not close” on page 159
• “Poor copy quality” on page 159
• “Partial document or photo copies” on page 160
158