Presence, Presence –60 – Polycom SOUNDPOINT SIP 3.1 User Manual

Page 114

Advertising
background image

Administrator’s Guide SoundPoint IP / SoundStation IP

4 - 60

until the registration is successful (for example, when the Internet link is once

again operational). While the primary server registration is unavailable, the

next highest priority server in the list will serve as the working server. As soon

as the primary server registration succeeds, it will return to being the working

server.

Recommended Practices for Fallback Deployments

In situations where server redundancy for fall-back purpose is used, the

following measures should be taken to optimize the effectiveness of the

solution:

1.

Deploy an on-site DNS server to avoid long call initiation delays that can

result if the DNS server records expire.

2.

Do not use OutBoundProxy configurations on the phone if the

OutBoundProxy could be unreachable when the fallback occurs.

SoundPoint IP phones can only be configured with one OutBoundProxy

per registration and all traffic for that registration will be routed through

this proxy for all servers attached to that registration. If Server 2 is not

accessible through the configured proxy, call signaling with Server 2 will

fail.

3.

Avoid using too many servers as part of the redundancy configuration as

each registration will generate more traffic.

4.

Educate users as to the features that will not be available when in

“fallback” operating mode.

Presence

The Presence feature allows the phone to monitor the status of other

users/devices and allows other users to monitor it. The status of monitored

users is displayed visually and is updated in real time in the Buddies display

screen or, for speed dial entries, on the phone’s idle display. Users can block

others from monitoring their phones and are notified when a change in

monitored status occurs. Phone status changes are broadcast automatically to

monitoring phones when the user engages in calls or invokes do-not-disturb.

The user can also manually specify a state to convey, overriding, and perhaps

masking, the automatic behavior.

Note

If reg.x.server.y.register is set to 0, then phone will not register to that server.
However, the INVITE will fail over to that server if all higher priority servers are
down.

Note

Notification when a change in monitored status occurs will be available in a
subsequent release.

Advertising