Polycom SOUNDPOINT SIP 3.1 - Manual (Page 180)

Administrator’s Guide SoundPoint IP / SoundStation IP
A - 26
up.welcomeSoundOnWarmBootE
nabled 0, 1 0 If set to 1, play welcome sound effect on warm
as well as cold boots.
If set to 0, only a cold boot will trigger the
welcome sound effect.
up.localClockEnabled 0, 1 1 If set to 1, display the date and time on the idle
display.
up.backlight.onIntensity 0 (off),
1 (low),
2 (medium), 3
(high) Null This parameter controls the intensity of the
LCD backlight when it turns on during normal
use of the phone.
The default value is medium.
up.backlight.idleIntensity 0 (off),
1 (low),
2 (medium), 3
(high) Null This parameter controls the intensity of the
LCD backlight when the phone is idle.
The default value is low.
Note: If idleIntensity is set higher than
onIntensity, it will be replaced with the
onIntensity value.
up.toneControl.bass -4 to 4, Null 0 Bass equalization control.
Each step is an increment of 1 dB at 225 kHz
and 2 dB < 225 Hz.
up.toneControl.treble -4 to 4, Null 0 Treble equalization control.
Each step is an increment of 1 dB at 3.7 kHz
and 2 dB > 10 kHz.
up.audioSetup.auxInput 0 - Other
Input,
1 - Polycom
Wireless Mic,
2 - off Null Auxiliary audio input.
If set to Null, default value is 2.
up.audioSetup.auxOutput 0 - Other
Input,
1 - Polycom
Wireless Mic,
2 - off Null Auxiliary audio output.
If set to Null, default value is 2.
up.idleTimeout positive
integer,
seconds Null Timeout for the idle display or default call
handling display.
If set to 0, there is no timeout.
If set to Null, the default timeout of 20 seconds
is used.
If set to value greater than 0, the timeout is for
that number of seconds
(maximum 65536).
Attribute
Permitted
Values
Default Interpretation