Call handling configuration <call, A-64 – Polycom SOUNDPOINT SIP 3.1 User Manual
Page 218
Administrator’s Guide SoundPoint IP / SoundStation IP
A - 64
This attribute also includes:
Configuration <cfg/>
This configuration attribute is defined as follows:
Call Handling Configuration <call/>
This configuration attribute is defined as follows:
Attribute
Permitted
Values
Default
Interpretation
httpd.cfg.enabled
0, 1
1
If set to 1, the HTTP server configuration interface
will be enabled.
httpd.cfg.port
1-65535
80
Port is 80 for HTTP servers. Care should be taken
when choosing an alternate port.
Attribute
Permitted
Values
Default
Interpretation
call.rejectBusyOnDnd
0, 1
1
If set to 1, reject all incoming calls with the
reason “busy” if do-not-disturb is enabled.
Note: This attribute is ignored when the line is
configured as shared. The reason being that
even though one party has turned on DND, the
other person/people sharing that line do not
necessarily want all calls to that number diverted
away.
Note: If server-based DND is enabled, this
parameter is disabled.
call.enableOnNotRegistered
0, 1
1
If set to 1, calls will be allowed when the phone is
not successfully registered, otherwise, calls will
not be permitted without a valid registration.
call.offeringTimeOut
positive
integer
60
Time in seconds to allow an incoming call to ring
before dropping the call, 0=infinite.
Note: The call diversion, no answer feature will
take precedence over this feature if enabled. For
more information, refer to
on page
call.ringBackTimeOut
positive
integer
60
Time in seconds to allow an outgoing call to
remain in the ringback state before dropping the
call, 0=infinite.