Polycom SOUNDPOINT SIP 3.1 - Manual (Page 96)

Administrator’s Guide SoundPoint IP / SoundStation IP
4 - 42
<efkprompt/>
This element describes the behavior of the user prompts.
The different blocks are uniquely identified by number following
efk.efkprompt
prefix (for example, efk.efkprompt.1.<suffix>).
This element contains the following parameters:
type The SIP method to be performed once the macro starts
executing. This parameter has the following values:
• If set to “invite “, the action required is performed
using the SIP INVITE method.
Note: This parameter is included for backwards
compatability only. Do not use if at all possible. If the
action.string contains types, this parameter is ignored. If
this parameter is omitted, the default is INVITE.
action.string The action string contains a macro definition of the
action to be performed.
For more information, refer to Macro Definition on page
4-44 .
This parameter must have a value and it cannot be Null.
Name Interpretation
Note In SIP 3.0, a maximum of four user prompts were supported. In SIP 3.1, a
maximum of ten user prompts are supported.
Name Interpretation
status This parameter has the following values:
• If set to 1, this key is enabled.
• If set to 0, this key is disabled.
This parameter must have a value and it cannot be Null.
Note: If a macro attempts to use a prompt that is
disabled or invalid, the macro execution fails.
label This parameter sets the prompt text that will be
presented to the user on the user prompt screen. The
value can be any string including the null string (in this
case, no label appears).
If this parameter is omitted, the Null string is used.
Note: If you exceed the phone physical layout text
limits, the text will be shortened and "..." will be
appended.