Nortel Networks NN43001-318 - Manual (Page 103)

Removing the test setup 103
Testing an ISDN BRI trunk
Procedure 41
Perform procedure to test an ISDN BRI trunk DSL
Step Action
1 Set up the ISDN trunk test configuration to be used, as described
previously in the chapter "Set up ISDN BRI test terminals and
trunks".
2 Place a call across the ISDN BRI trunk.
3 Complete the call and hang up.
—End—
Removing the test setup
After acceptance testing has been completed and the results show the
system is operating correctly, remove the ISDN BRI terminal setup and
configure ISDN BRI equipment according to the customer configuration.
If the actual customer configuration was used to perform these tests, no
changes are needed.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.