Nortel Networks NN43001-318 - Manual (Page 105)

105
Generating traffic reports
Contents
This section contains information on the following topics:
"Introduction" (page 105)
Introduction
This chapter describes how to generate traffic reports to verify that the traffic
generated during voice and data transmission testing has been stored by
the system and can be printed on demand. To verify traffic generated during
acceptance testing, use the following command:
INVS (options)*
The asterisk (*) denotes that the ENTER key must be pressed after the
desired option numbers are entered.
Reports are generated using one or more of the following option numbers.
Option Meaning
1 Network traffic report
11 ISDN BRI MISP and/or BRSC traffic report
12 ISDN BRI MISP and/or BRSC D-channel management
messages report
13 ISDN BRI MISP and/or BRSC messages report
14 Trunk DSL system traffic report
15 MPH traffic report
For example, to verify ISDN BRI traffic generated during acceptance testing,
select the network traffic report and the MISP traffic report as follows:
INVS 1 11
The system printer should print these two reports. Check the reports to
make sure the traffic generated during the test is reflected in the reports.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.