Nortel Networks NN43001-318 - Manual (Page 14)

14 Preparing for installation
1 Large System Installation and Commissioning (NN43021-310) for a
description of how to install the modules.
Unpacking and inspecting
ISDN BRI cards and external communication cables are shipped in separate
packages. To unpack them, follow the general precautions recommended
by computer and telephone equipment manufacturers.
• Remove items that generate static charge from the installation site.
• If the installation site is carpeted, spray it with an antistatic spray.
• Ground yourself before handling any equipment.
• Carefully remove the equipment from its packaging. Do not puncture or
tear the containers. Use scissors or a utility knife.
• Inspect the equipment for obvious faults or damage. Report any
damaged component to your sales representative and the carrier who
delivered the equipment.
• When unpacking the circuit cards, hold them only by their nonconductor
edges. Do not touch connector pins or components.
• Keep the circuit cards in their antistatic bags until you are ready to
install them.
• Do not stack the plug-in cards on top of each other. This can damage
the components and the printed circuits on the cards.
Taking inventory
After unpacking, verify that all the equipment necessary is at the site
before installation begins. Check the equipment received against the
shipping documents. Note any shortages and report them to your sales
representative.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.