Nortel Networks NN43001-318 - Manual (Page 93)

Voice calls 93
• Call Join two separate parties on the terminal
• disconnect from the Conference
Procedure 31
Perform an ISDN BRI Conference test
Step Action
The same procedures can be used to test ISDN BRI NI-1 or ETSI
Conference.
1 In the DSL configuration in LD 27, set PRID = 6 to select the National
ISDN-1 protocol, or set PRID = 2 for the ETSI protocol.
2 In the TSP configuration in LD 27, define conference under FEATID:
FEATID aaa mmm <nnn>, where
aaa = A03 (3-party conference) or A06 (6-party conference)
mmm = feature activation ID (0 - 127)
nnn = feature indication ID (0 - 127) (If nnn is not entered, it is
assumed
to be the same as mmm)
3 Select National ISDN-1 or ETSI protocol on the ISDN BRI terminal if
signaling type/protocol is configurable.
4 On the ISDN BRI terminal, configure Conference. This procedure
largely depends on the implementation of feature key management
on individual terminals. In general:
a. The terminal provides Conference as a selectable feature to be
programmed on a hard/soft key. For example, on a soft key
on an M5317TDX, select FA to be FCC; on a hard key on an
M5209TDcp, select CONF.
b. The Conference key number selected on the terminal must
correspond to the feature activation ID entered for the TSP in
LD 27.
5 Configure at least two DN appearances on the ISDN BRI terminal.
On some ISDN BRI terminals, the second DN appearance allows
the user to initiate the second call.
6 Place an outgoing call from the ISDN BRI terminal.
7 After the call is established, press the Conference key. The first call
is put on hold automatically; a second key is lit to allow the user
to place the second call.
8 Place another outgoing call from the second key.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.