Nortel Networks NN43001-318 - Manual (Page 38)

38 Installing ISDN BRI hardware
Figure 10
Connect the ISDN BRI network termination (NT1) to the U interface
Installing ISDN BRI hardware for trunk applications
This section explains how to install ISDN BRI hardware to support ISDN
BRI trunk applications. The system must already be installed and operating
according to the instructions in Communication Server 1000M and Meridian
1 Large System Installation and Commissioning (NN43021-310) before
performing these procedures.
For a successful installation, perform these procedures in the order listed
below:
1. Select the card slots where the ISDN BRI cards will be located.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.