Nortel Networks NN43001-318 - Manual (Page 81)

Installation procedures 81
21 Press YES to enter datafill.
22 Press YES to delete existing datafill.
23 Press KEY# then use to keypad to enter the key number you want
to program.
24 Press EDIT DN then use the keypad to enter the digits of the DN.
25 Press OK then SAVE after each DN.
26 Repeat step 18 to step 25 for each voice DN keypad you want.
27 Press INSTALL and begin at step 4 , If you entered incorrect data. If
the entries were correct, press EXIT.
28 Make a voice call to make sure the telephone is operational.
—End—
Table 19
M5317TDX terminal error codes
Error Code
Number Description
>>10<< S/T-loop sync loss and/or Frame sync loss.
>>11<< L1 transmit timer expired.
>>21<< Voice TEI removed by network.
>>22<< Circuit data TEI removed by network.
>>23<< Voice and circuit data TEI removed.
>>24<< X25 TEI removed.
>>25<< Voice and X25 TEI removed.
>>26<< Circuit data and X25 TEI removed.
>>27<< All TEI removed.
>>28<< Voice link not established.
>>29<< Circuit data link not established.
>>2A<< X25 link not established.
>>2B<< No Layer 2 link established.
>>30<< No Layer 3 link established.
>>31<< No valid voice SPID.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.