Tally Genicom 6600 - Manual (Page 168)

168
Chapter 9 PGL Commands
NOTE: You may embed Horizontal Duplication commands within Vertical
Duplication commands, but you cannot embed Horizontal Duplication
commands within Horizontal Duplication commands.
Vertical Duplication Command
This command allows you to duplicate specific elements vertically on a form,
such as lines, logos, barcodes, etc. The basic command is:
NOTE: You may embed Horizontal Duplication commands within Vertical
Duplication commands, but you cannot embed Vertical Duplication
commands within Vertical Duplication commands.
HDUP;OFF Termines Horizontal duplication
mode. Enter HDUP;OFF
Table 12. Horizontal Duplication Command
Field Function Option/Modifier Selections
Table 13. Vertical Duplication Command
Field Function Option/Modifier Selections
VDUP; Command Specifier Enter VDUP;
dups; Specifies number of duplications. Enter the desired number of duplications.
The valid range of values is 1-255. Make
sure there is enough room on the form for
the duplication(s) to print.
dist Specifies the distance from the
starting point of one element to the
next duplication. This parameter
may specify columns or dots or a
combination of columns and dot
positions. Enter a column or dot distance or a
combination of columns and dots.
Whether in columns or dots depends on
the SCALE Command. You may also use
the XX.YY format for plotting duplication
print locations explained earlier in the
Standards Section.
element Defines the element that will be
duplicated.
You may define a line, call a logo or
a barcode, etc. Enter print information in proper format.
VDUP;OFF Termines Vertical duplication
mode. Enter VDUP;OFF