Tally Genicom 6600 - Manual (Page 199)

Scale Command (Create)
199
Scale Command (Create)
There are two commands that define the format that will be used in specifying
where various elements of the form will be placed.
Table 36. Scale Command
Field Function Option/Modifier Selections
Dot Scale Placement
SCALE; Command Specifier. Enter SCALE;
DOT Specifies that placement will be
done using a dot-scale. Enter DOT to specify a dot measurement
scale (dot-columns and dot-rows).
Character Scale Placement
SCALE; Command Specifier. Enter SCALE;
CHAR Specifies that placement will be
done using a character scale. Enter CHAR; to specify a character
measurement scale (columns and rows).
;LPI An optional parameter that can be
used to specify Lines Per Inch
setting for print output. Selections that can be used are 6, 8, 9,
and 10. No value will result in the default
setting of 6 LPI. Do not forget the
parameter delimiter.
;CPI An optional parameter that can be
used to specify Character Per Inch
setting for print output. Selections that can be used are 10, 12, 13,
15, and 17. No value will result in the
default setting of 10 LPI.