Tally Genicom 6600 - Manual (Page 188)

188
Chapter 9 PGL Commands
Table 24. CREATE LOGO Mode Command
Field Function Option/Modifier Selections
LOGO; Initiates Create LOGO Mode. Enter the current Special Function Control
Character followed by LOGO, then end the
entry with the parameter delimiter.
Name; Enter the name of the Logo in this
field. LOGO names are allowed a maximum of
eight characters. The follownig ASCII
characters may be used in form names:
• Upper and lower-case A - Z
(HEX 41 - 5A and 61 - 7A)
• Number 0 - 9 (HEX 30 - 39)
• Dollar sign $ (HEX 24)
• Percent Sign % (HEX 25)
• Dash - (HEX 2D)
• At sign @ (HEX 40)
• Braces { } (HEX 7B and 7D)
• Parens ( ) (HEX 28 and 29)
• Tilde ~ (HEX 7E)
• Single quotes ‘ ‘ (Hex 60 and 27)
• Exclamation point ! (HEX 21)
• Pound sign # (HEX 23)
• Amersand & (HEX 26)
NOTE: Make sure your LOGO name is
not identical to one that is already
stored in memory. the new LOGO
will replace the old LOGO if this
happens.
VL; Vertical size of the Grid at 72 DPI. Enter a vlue from 1-252, followed by the
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
HL Horizontal size of the Grid at 60
DPI. Enter a vlue from 1-240, followed by the
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
Row# Specifies which row in the Grid is
being defined for printing dots. Enter each row that will be printed on a
separate line, followed by the parameter
delimiter. rows in the Grid are numbered
sequentially from top to bottom of the Grid.