Tally Genicom 6600 - Manual (Page 91)

Vertical Repeat, Version 2
91
Vertical Repeat, Version 2
Vertical repetition can be selected by bracketing the commands and data to
be repeated with the commands shown below. Both Graphics and non-
Graphics commands and data are repeated vertically.
Command ^IREPV,n,vd^G <data>^IREPE
Arguments
^IREPV Vertical Repeat Command
n The number of times the data is to be repeated (1
to 9999).
v Vertical space between each repetition in 0.10
increments (1 to 132).
d Additional vertical space between repetitions in dot
rows (0 to 9).
^G Command Terminator
<data> The data to be repeated.
^IREPE Repeat Terminator, turns OFF the Horizontal
Repeat Mode.
Example 1: The Graphics Pass ^IREPV,3,12,^G^M0202000REPEAT 3
TIMES^-^IREPE^- prints:
Example 2: The command sequence ^IREPV,3,13^G^M0202000GRAPHICS
PASS^-^*NON-GRAPHICS SEQUENCE^*^IREPE^- mixes
Graphics Pass text with standard text and prints the following: